The BESS Exchange is sponsored by Edge On Up › BESS Forums › Knife Making & Bladesmithing in Memory of Mark Reich v
Kally build - some questions

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Kally build - some questions
Ken S Offline
Senior Member
****
Posts: 504
Threads: 55
Joined: Feb 2017
#12
02-07-2018, 08:23 PM
May I offer my humble, extremely low tech suggestion? I place two large boxes of cat litter on the low shelf of my ("table mount") drill press. It provides stability; is easily removed when I move the drill press with my appliance dolly (the old guy's alternative for youthful strength or a strong friend); and requires no hacksawing or filing to install.

Ken
Find
Reply


Messages In This Thread
Kally build - some questions - by wadebevan - 02-03-2018, 09:21 AM
RE: Kally build - some questions - by EOU - 02-03-2018, 11:32 AM
RE: Kally build - some questions - by wadebevan - 02-03-2018, 11:38 AM
RE: Kally build - some questions - by Mark Reich - 02-03-2018, 01:40 PM
RE: Kally build - some questions - by wadebevan - 02-03-2018, 02:22 PM
RE: Kally build - some questions - by Mark Reich - 02-03-2018, 09:37 PM
RE: Kally build - some questions - by wadebevan - 02-03-2018, 09:46 PM
RE: Kally build - some questions - by wadebevan - 02-04-2018, 12:45 PM
RE: Kally build - some questions - by EOU - 02-07-2018, 04:42 PM
RE: Kally build - some questions - by wadebevan - 02-07-2018, 06:16 PM
RE: Kally build - some questions - by grepper - 02-07-2018, 07:54 PM
RE: Kally build - some questions - by Ken S - 02-07-2018, 08:23 PM
RE: Kally build - some questions - by grepper - 02-07-2018, 08:42 PM
RE: Kally build - some questions - by wadebevan - 02-07-2018, 09:18 PM
RE: Kally build - some questions - by Mark Reich - 02-19-2018, 01:42 PM
RE: Kally build - some questions - by wadebevan - 02-20-2018, 10:21 AM
RE: Kally build - some questions - by Mark Reich - 02-20-2018, 08:38 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)