The BESS Exchange is sponsored by Edge On Up › BESS Forums › Knife Making & Bladesmithing in Memory of Mark Reich v
Kally build - some questions

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Kally build - some questions
wadebevan Offline
Member
***
Posts: 100
Threads: 11
Joined: Mar 2017
#10
02-07-2018, 06:16 PM
Good point. The base is 24x24" 2 inch 1/4 wall c-channel, so it does weigh a fair amount.
Though I have been a bit worried that it would be top heavy, which could be a disaster if it fell during operation.
Perhaps some more plate steel is in order Smile
Thanks for the input!
Find
Reply


Messages In This Thread
Kally build - some questions - by wadebevan - 02-03-2018, 09:21 AM
RE: Kally build - some questions - by EOU - 02-03-2018, 11:32 AM
RE: Kally build - some questions - by wadebevan - 02-03-2018, 11:38 AM
RE: Kally build - some questions - by Mark Reich - 02-03-2018, 01:40 PM
RE: Kally build - some questions - by wadebevan - 02-03-2018, 02:22 PM
RE: Kally build - some questions - by Mark Reich - 02-03-2018, 09:37 PM
RE: Kally build - some questions - by wadebevan - 02-03-2018, 09:46 PM
RE: Kally build - some questions - by wadebevan - 02-04-2018, 12:45 PM
RE: Kally build - some questions - by EOU - 02-07-2018, 04:42 PM
RE: Kally build - some questions - by wadebevan - 02-07-2018, 06:16 PM
RE: Kally build - some questions - by grepper - 02-07-2018, 07:54 PM
RE: Kally build - some questions - by Ken S - 02-07-2018, 08:23 PM
RE: Kally build - some questions - by grepper - 02-07-2018, 08:42 PM
RE: Kally build - some questions - by wadebevan - 02-07-2018, 09:18 PM
RE: Kally build - some questions - by Mark Reich - 02-19-2018, 01:42 PM
RE: Kally build - some questions - by wadebevan - 02-20-2018, 10:21 AM
RE: Kally build - some questions - by Mark Reich - 02-20-2018, 08:38 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)