08-15-2020, 11:48 AM
(This post was last modified: 08-15-2020, 01:15 PM by Oceanrider.)
Grepper
You say “Kally” in posts above and I think you are referring to the machine, not the rest/angle guide that Brian is talking about? Is this a general nickname for the machine everywhere, or just here on this forum?
Do you know if a guide like the Surgi-Sharp can be attached to the new Platen?
Edit:
Further reading I found a tread where it looks like you are the designer of the “Kally Rest” http://bessex.com/forum/showthread.php?tid=271
Do you feel that edge-trailing is a better method than edge-leading on a belt sander?
You say “Kally” in posts above and I think you are referring to the machine, not the rest/angle guide that Brian is talking about? Is this a general nickname for the machine everywhere, or just here on this forum?
Do you know if a guide like the Surgi-Sharp can be attached to the new Platen?
Edit:
Further reading I found a tread where it looks like you are the designer of the “Kally Rest” http://bessex.com/forum/showthread.php?tid=271
Do you feel that edge-trailing is a better method than edge-leading on a belt sander?