|
pyroceram
|
 (06-16-2017, 03:35 AM)Ken S Wrote: I plan to use epoxy as the adhesive to hold the Pyroceram to the steel platen. Any thoughts on adhesives? Sharpeners often use two component epoxy. E.g. JB weld epoxy can theoretically withstand temperatures up to 550F. Grinding sometimes may generate static electricity. In this case you can use a spray which prevents its built-up. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
RE: pyroceram - by Rupert Lucius - 06-13-2017, 08:06 PM
RE: pyroceram - by Ken S - 06-13-2017, 08:30 PM
RE: pyroceram - by Rupert Lucius - 06-13-2017, 09:18 PM
RE: pyroceram - by Ken S - 06-14-2017, 04:10 AM
RE: pyroceram - by Rupert Lucius - 06-14-2017, 07:22 AM
RE: pyroceram - by Rupert Lucius - 06-14-2017, 07:49 PM
RE: pyroceram - by Ken S - 06-14-2017, 07:34 AM
RE: pyroceram - by Ken S - 06-14-2017, 09:02 PM
RE: pyroceram - by Rupert Lucius - 06-14-2017, 09:42 PM
RE: pyroceram - by Jeremy - 06-15-2017, 06:54 AM
RE: pyroceram - by Ken S - 06-15-2017, 10:21 AM
RE: pyroceram - by Ken S - 06-15-2017, 04:32 PM
RE: pyroceram - by Rupert Lucius - 06-15-2017, 04:39 PM
RE: pyroceram - by Ken S - 06-15-2017, 05:33 PM
RE: pyroceram - by Rupert Lucius - 06-15-2017, 08:07 PM
RE: pyroceram - by Jan - 06-16-2017, 02:27 AM
RE: pyroceram - by Ken S - 06-16-2017, 03:35 AM
RE: pyroceram - by Jan - 06-16-2017, 01:00 PM
RE: pyroceram - by Rupert Lucius - 06-16-2017, 12:02 PM
RE: pyroceram - by grepper - 06-16-2017, 01:24 PM
RE: pyroceram - by Ken S - 06-16-2017, 04:45 PM
RE: pyroceram - by Jan - 06-17-2017, 01:26 AM
RE: pyroceram - by Jeremy - 06-17-2017, 08:51 AM
RE: pyroceram - by Ken S - 06-17-2017, 09:35 AM
RE: pyroceram - by Mark Reich - 06-17-2017, 10:24 AM
RE: pyroceram - by Ken S - 06-17-2017, 12:31 PM
RE: pyroceram - by Jeremy - 06-18-2017, 09:42 PM
|
