06-14-2017, 07:22 AM
(This post was last modified: 06-14-2017, 07:31 AM by Rupert Lucius.)
Ken
Replace the two machine screws (adjustment screws for tracking) with knob screws from the local hardware store.
Easier to remove tension (without screwdriver) from one side and apply tension to the opposite side.
The knob screws we find at our local hardware store (the shortest threaded length) are a thread or two too long to allow contact and compressing the spring - use a washer between the spring end and plastic knob (effective way to shorten the threaded length).
Yes! Mr. B is an asset to us sharpeners, I, appreciate his contributions.
Love your Viel.
Rupert
Reply to Post #5
Not sure that I understand the question - we have never noticed any problems with sharpening knives after shortening our platens.
Please, this is not my answer to your question.
Rupert
Replace the two machine screws (adjustment screws for tracking) with knob screws from the local hardware store.
Easier to remove tension (without screwdriver) from one side and apply tension to the opposite side.
The knob screws we find at our local hardware store (the shortest threaded length) are a thread or two too long to allow contact and compressing the spring - use a washer between the spring end and plastic knob (effective way to shorten the threaded length).
Yes! Mr. B is an asset to us sharpeners, I, appreciate his contributions.
Love your Viel.
Rupert
Reply to Post #5
Not sure that I understand the question - we have never noticed any problems with sharpening knives after shortening our platens.
Please, this is not my answer to your question.
Rupert