06-05-2017, 07:57 PM
I have noticed the same thing, and it gets frustrating, especially when it is on one small section of the blade!
I've considered taking a mapp gas torch to a blade when this bending back and forth over and over occurs without the burr actually falling off.
Just a quick pass of the torch to see if it ignites the burr. Of course this would temper the edge left behind where it is the thinnest, so, probably doesn't help the edge much... just a curiosity.
I've considered taking a mapp gas torch to a blade when this bending back and forth over and over occurs without the burr actually falling off.
Just a quick pass of the torch to see if it ignites the burr. Of course this would temper the edge left behind where it is the thinnest, so, probably doesn't help the edge much... just a curiosity.