The BESS Exchange is sponsored by Edge On Up › BESS Forums › Edge Sharpness Testing v
Protocol for BESS measurements?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Protocol for BESS measurements?
Macjaynard Offline
Junior Member
**
Posts: 1
Threads: 0
Joined: Apr 2026
#6
04-30-2026, 02:02 PM
(04-30-2026, 04:42 AM)WI_Hedgehog Wrote: So there's not an official 100g tension the wire should be under?

Apparently some people "cheat the system" by over-tensioning the wire to create artificially low results, so tension contributes to the BESS score to some tangible degree.

I would love to see an official response verifying the 100g tension, if at all possible.  I saw this somewhere but can't find the reference anymore.
Thanks!
Find
Reply


Messages In This Thread
Protocol for BESS measurements? - by WiSpi - 04-19-2023, 11:35 AM
RE: Protocol for BESS measurements? - by grepper - 04-19-2023, 07:06 PM
RE: Protocol for BESS measurements? - by WiSpi - 04-20-2023, 06:24 AM
RE: Protocol for BESS measurements? - by grepper - 04-20-2023, 09:27 AM
RE: Protocol for BESS measurements? - by Macjaynard - 04-30-2026, 02:02 PM
RE: Protocol for BESS measurements? - by grepper - 05-01-2026, 04:35 PM
RE: Protocol for BESS measurements? - by grepper - 05-02-2026, 08:31 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)