The BESS Exchange is sponsored by Edge On Up › BESS Forums › Burr Removal Methods, Testing and Results v
buffing speed

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
buffing speed
Ken S Offline
Senior Member
****
Posts: 504
Threads: 55
Joined: Feb 2017
#6
04-19-2017, 07:25 PM
No problem. The Loctite is drying. (Hopefully) either it will work or provide a good substrate "primer" for whatever glue follows.  Smile

Ken
Find
Reply


Messages In This Thread
buffing speed - by Ken S - 04-14-2017, 04:20 AM
RE: buffing speed - by grepper - 04-16-2017, 08:57 PM
RE: buffing speed - by Ken S - 04-17-2017, 03:16 AM
RE: buffing speed - by Ken S - 04-19-2017, 06:18 PM
RE: buffing speed - by grepper - 04-19-2017, 06:52 PM
RE: buffing speed - by Ken S - 04-19-2017, 07:25 PM
RE: buffing speed - by grepper - 04-19-2017, 08:54 PM
RE: buffing speed - by Ken S - 04-20-2017, 06:39 AM
RE: buffing speed - by Ken S - 04-21-2017, 06:29 PM
RE: buffing speed - by Mark Reich - 04-25-2017, 05:08 PM
RE: buffing speed - by Ken S - 05-21-2017, 04:48 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)