07-05-2019, 08:29 AM
Rick,
When I became interested in converting my Viel (inspired by Max the Knife), I did not realize that it would be in pieces during so many modifications. I called the process "Gen I, Gen Ii, and Gen III". With all the changes, "Gen III.06, etc" might be more accurate. While I certainly understand the desire to complete the project, the simplicity of the Viel makes it easy to make later modifications if desired.
I found the fit of the modified Viel drive pulley on the PSI shaft to be more of a force fit than I wanted. With the motor mounted on the frame, I ran the motor with a file against the shaft until I liked the fit.
After I liked the fit, I pit a clamp on the shaft to prevent rotation and filed a flat for the pulley locking screw.
Adding the second pair of alignment screws is easily done. I am still considering it, but have not felt the need. I did switch to thumb aligning screws on the unit I gave to my nephew, however, I am content with the original screws on mine. If I decide to switch later, it is easily done.
I use my Viel more often for general shop projects than sharpening. It is a versatile tool.
Ken
When I became interested in converting my Viel (inspired by Max the Knife), I did not realize that it would be in pieces during so many modifications. I called the process "Gen I, Gen Ii, and Gen III". With all the changes, "Gen III.06, etc" might be more accurate. While I certainly understand the desire to complete the project, the simplicity of the Viel makes it easy to make later modifications if desired.
I found the fit of the modified Viel drive pulley on the PSI shaft to be more of a force fit than I wanted. With the motor mounted on the frame, I ran the motor with a file against the shaft until I liked the fit.
After I liked the fit, I pit a clamp on the shaft to prevent rotation and filed a flat for the pulley locking screw.
Adding the second pair of alignment screws is easily done. I am still considering it, but have not felt the need. I did switch to thumb aligning screws on the unit I gave to my nephew, however, I am content with the original screws on mine. If I decide to switch later, it is easily done.
I use my Viel more often for general shop projects than sharpening. It is a versatile tool.
Ken