04-09-2017, 07:00 AM
like rupert said, the newer model veil's have a larger frame hole............i have some pics................my machine guy welded two nuts to veil frame and then used the mounting arm to connect to frame.........he bend the arm 90* out of the way and that was it.
he did machine out the Veil pulley to match oversized penn state motor.
now on my rally, i had the actually motor shaft resized to 1/2"..............either way is ok.
now the wooden enclosed that peter makes is a fine ticket..........make the kally vertical or horizontal..............i also have bicycle grip mounted on top of all mine.............used for carrying from truck to market/show....................I FOUND OUT THAT IF I.........loosen the set screw and move grip to front................it acts as a leg and i can flip kally horizontally that was as well.
.
.
.
he did machine out the Veil pulley to match oversized penn state motor.
now on my rally, i had the actually motor shaft resized to 1/2"..............either way is ok.
now the wooden enclosed that peter makes is a fine ticket..........make the kally vertical or horizontal..............i also have bicycle grip mounted on top of all mine.............used for carrying from truck to market/show....................I FOUND OUT THAT IF I.........loosen the set screw and move grip to front................it acts as a leg and i can flip kally horizontally that was as well.
.
.
.
.
.
<")))))<>(
.
<")))))<>(