The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 871 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 871 errorHandler->error



The BESS Exchange is sponsored by Edge On Up › BESS Forums › Relevant General Discussion v
Viel conversion

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Viel conversion
Ordener Offline
Junior Member
**
Posts: 18
Threads: 4
Joined: Sep 2017
#1
01-05-2019, 09:02 PM
Hey guys!
I’m looking to install a 12 volt Penn State motor on my Viel 1X42. I would prefer to use my 6” drive wheel, and bore it out to fit the new motor. Does anyone offer an adapter plate that I can simply bolt on to my Viel frame, and still utilize my 6” pulley? Do they make a 15mm drill bit, or an imperial size that matches? 
Thanks! 
Garry Ordener 
Garry’s Knife Sharpening
Find
Reply


Messages In This Thread
Viel conversion - by Ordener - 01-05-2019, 09:02 PM
RE: Viel conversion - by Rick Kr - 01-06-2019, 11:15 AM
RE: Viel conversion - by Ordener - 01-06-2019, 12:21 PM
RE: Viel conversion - by Rick Kr - 01-06-2019, 12:32 PM
RE: Viel conversion - by Ordener - 01-06-2019, 12:45 PM
RE: Viel conversion - by Ken S - 01-06-2019, 01:02 PM
RE: Viel conversion - by Ordener - 01-06-2019, 02:47 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)