EDGE RETENTION/ROLLING PART II

[Bud]

Here's the way I see it. If you have a long sloping bevel at say 5 degrees and then a shorter bevel of say 15 degrees then the long bevel is primary and the short is secondary. If you have a short 15 degree bevel like Mike's test blades and then a very small bevel of 20 degrees I call the 15 degree bevel primary and the 20 degree micro bevel. I understand that someone or everyone could mix those up or reverse them and they'd still be correct. Its just how I think about it. It would be good if everyone was reading out of the same book though. I'd be willing to change how I look at things.