The BESS Exchange is sponsored by Edge On Up › BESS Forums › Relevant General Discussion v
Introduction, and new Viel user

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Introduction, and new Viel user
Ken S Offline
Senior Member
****
Posts: 504
Threads: 55
Joined: Feb 2017
#26
04-24-2018, 09:54 AM
Excellent points, Mark. Just one minor comment: When the Kally is fitted with the same Penn State Industries variable speed motor, the low speed is essentially the same as the Viel. (My Kally was a "skeleton", no motor.)

Ken
Find
Reply


Messages In This Thread
Introduction, and new Viel user - by bruin - 04-15-2018, 11:04 PM
RE: Introduction, and new Viel user - by grepper - 04-15-2018, 11:35 PM
RE: Introduction, and new Viel user - by Ken S - 04-16-2018, 04:59 AM
RE: Introduction, and new Viel user - by EOU - 04-16-2018, 12:19 PM
RE: Introduction, and new Viel user - by Ken S - 04-16-2018, 02:51 PM
RE: Introduction, and new Viel user - by grepper - 04-16-2018, 05:46 PM
RE: Introduction, and new Viel user - by grepper - 04-16-2018, 07:07 PM
RE: Introduction, and new Viel user - by Ken S - 04-16-2018, 07:37 PM
RE: Introduction, and new Viel user - by bruin - 04-17-2018, 12:30 AM
RE: Introduction, and new Viel user - by grepper - 04-17-2018, 09:53 AM
RE: Introduction, and new Viel user - by bruin - 04-17-2018, 11:47 PM
RE: Introduction, and new Viel user - by Ken S - 04-18-2018, 08:29 AM
RE: Introduction, and new Viel user - by bruin - 04-19-2018, 06:05 PM
RE: Introduction, and new Viel user - by grepper - 04-19-2018, 07:56 PM
RE: Introduction, and new Viel user - by bruin - 04-20-2018, 01:12 AM
RE: Introduction, and new Viel user - by Ken S - 04-20-2018, 08:18 PM
RE: Introduction, and new Viel user - by Ken S - 04-20-2018, 08:30 PM
RE: Introduction, and new Viel user - by bruin - 04-20-2018, 10:26 PM
RE: Introduction, and new Viel user - by grepper - 04-20-2018, 11:12 PM
RE: Introduction, and new Viel user - by Ken S - 04-21-2018, 07:21 AM
RE: Introduction, and new Viel user - by Ken S - 04-24-2018, 09:54 AM
RE: Introduction, and new Viel user - by bruin - 04-26-2018, 11:51 PM
RE: Introduction, and new Viel user - by bruin - 04-27-2018, 12:12 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)