04-17-2018, 10:54 AM
Well shucks Mr. Grepper, that is super kind of you, but I don't mind sharing an office with you at all. 
Y'all make me proud to be a part of this forum. The generosity and sharing of solid information is unparalleled, and truly commendable.
Excellent work, Gentlemen!
Kevin, it's great to have you here. It's my pleasure.
About the glass, you do need to round the sharp corners of the top and bottom faces. You really don't need to remove much material at all, but pyroceram is very tough to grind. Coarse belts will break little chips out, and the results are ugly.
I recommend a 400 grit Deerfos. It's best to work on both corners a little at a time, so you don't wear your belt out on one corner, and have to use up two belts.
If you don't mind sharing pictures of your Viel, I'm sure everyone would be interested in what you've accomplished.
Y'all make me proud to be a part of this forum. The generosity and sharing of solid information is unparalleled, and truly commendable.
Excellent work, Gentlemen!
Kevin, it's great to have you here. It's my pleasure.
About the glass, you do need to round the sharp corners of the top and bottom faces. You really don't need to remove much material at all, but pyroceram is very tough to grind. Coarse belts will break little chips out, and the results are ugly.
I recommend a 400 grit Deerfos. It's best to work on both corners a little at a time, so you don't wear your belt out on one corner, and have to use up two belts.
If you don't mind sharing pictures of your Viel, I'm sure everyone would be interested in what you've accomplished.