The BESS Exchange is sponsored by Edge On Up › BESS Forums › Relevant General Discussion v
Hardness vs performance

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Hardness vs performance
me2 Offline
Member
***
Posts: 101
Threads: 2
Joined: Dec 2017
#18
03-01-2018, 06:03 AM
That's very interesting.  I've never seen anyone do it that way.  When you were working out your process, did you try going the opposite way?  Fully harden the blade first, temper to 650 to 750 F, then torch harden the edge?  I know a couple makers that take pre-hardened fully hardened blades at about 49 to 51 HRc and torch harden the edge.
Find
Reply


Messages In This Thread
Hardness vs performance - by grepper - 02-15-2018, 10:33 PM
RE: Hardness vs performance - by me2 - 02-16-2018, 06:08 AM
RE: Hardness vs performance - by Mark Reich - 02-16-2018, 09:11 AM
RE: Hardness vs performance - by me2 - 02-16-2018, 10:28 AM
RE: Hardness vs performance - by Mark Reich - 02-16-2018, 11:14 AM
RE: Hardness vs performance - by me2 - 02-16-2018, 11:45 AM
RE: Hardness vs performance - by Mark Reich - 02-19-2018, 04:15 PM
RE: Hardness vs performance - by Edgepal - 02-16-2018, 01:31 PM
RE: Hardness vs performance - by EOU - 02-16-2018, 02:29 PM
RE: Hardness vs performance - by Edgepal - 02-16-2018, 02:59 PM
RE: Hardness vs performance - by KnifeGrinders - 02-16-2018, 06:06 PM
RE: Hardness vs performance - by Rupert Lucius - 02-19-2018, 05:30 PM
RE: Hardness vs performance - by Rupert Lucius - 02-19-2018, 05:42 PM
RE: Hardness vs performance - by Mark Reich - 02-27-2018, 11:44 AM
RE: Hardness vs performance - by grepper - 02-19-2018, 06:24 PM
RE: Hardness vs performance - by me2 - 02-19-2018, 07:03 PM
RE: Hardness vs performance - by Mark Reich - 02-28-2018, 11:24 PM
RE: Hardness vs performance - by me2 - 03-01-2018, 06:03 AM
RE: Hardness vs performance - by EOU - 03-01-2018, 09:39 AM
RE: Hardness vs performance - by Jan - 03-01-2018, 04:16 PM
RE: Hardness vs performance - by Mark Reich - 03-01-2018, 08:59 PM
RE: Hardness vs performance - by scott.livesey - 03-02-2018, 06:59 PM
RE: Hardness vs performance - by EOU - 03-03-2018, 02:26 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)