The BESS Exchange is sponsored by Edge On Up › BESS Forums › All About Edges v
Edge Geometry Discussion

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Edge Geometry Discussion
Bud Offline
Member
***
Posts: 160
Threads: 0
Joined: Mar 2017
#2
01-28-2018, 04:02 PM
Thank you for your time Mr. Me2. I'm going to measure when I get to the shop tomorrow. I'm going to say that my knife is going to be thicker than yours.
Find
Reply


Messages In This Thread
Edge Geometry Discussion - by me2 - 01-28-2018, 03:02 PM
RE: Edge Geometry Discussion - by Bud - 01-28-2018, 04:02 PM
RE: Edge Geometry Discussion - by me2 - 01-28-2018, 07:22 PM
RE: Edge Geometry Discussion - by scott.livesey - 01-28-2018, 08:21 PM
RE: Edge Geometry Discussion - by grepper - 01-28-2018, 08:51 PM
RE: Edge Geometry Discussion - by Ken S - 01-29-2018, 05:05 AM
RE: Edge Geometry Discussion - by scott.livesey - 01-29-2018, 11:59 AM
RE: Edge Geometry Discussion - by grepper - 01-29-2018, 01:03 PM
RE: Edge Geometry Discussion - by scott.livesey - 01-29-2018, 08:45 PM
RE: Edge Geometry Discussion - by Bud - 01-30-2018, 07:22 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)