The BESS Exchange is sponsored by Edge On Up › BESS Forums › Relevant General Discussion v
converting a Kalamazoo 1SM

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
converting a Kalamazoo 1SM
grepper Offline
Administrator
*******
Posts: 947
Threads: 74
Joined: Mar 2017
Reputation: 0
#14
01-07-2018, 12:43 PM
You are right, Mr. Mark. Aluminum conducts heat way better than stainless steel. You know, they make heat-sinks out of the stuff. As far as common metals go, stainless steel is a rather poor conductor of heat. I suspect what this means is that when grinding heat is not readily lost to the cooler body of the blade.

https://www.engineeringtoolbox.com/therm...d_429.html
Find
Reply


Messages In This Thread
converting a Kalamazoo 1SM - by Ken S - 12-17-2017, 08:02 PM
RE: converting a Kalamazoo 1SM - by grepper - 12-17-2017, 09:08 PM
RE: converting a Kalamazoo 1SM - by Ken S - 12-18-2017, 05:06 AM
RE: converting a Kalamazoo 1SM - by EOU - 12-18-2017, 10:01 AM
RE: converting a Kalamazoo 1SM - by Ken S - 12-18-2017, 10:30 AM
RE: converting a Kalamazoo 1SM - by Ken S - 01-04-2018, 05:51 PM
RE: converting a Kalamazoo 1SM - by grepper - 01-04-2018, 08:18 PM
RE: converting a Kalamazoo 1SM - by Ken S - 01-05-2018, 12:28 PM
RE: converting a Kalamazoo 1SM - by grepper - 01-05-2018, 07:08 PM
RE: converting a Kalamazoo 1SM - by Ken S - 01-05-2018, 08:05 PM
RE: converting a Kalamazoo 1SM - by grepper - 01-05-2018, 08:42 PM
RE: converting a Kalamazoo 1SM - by Ken S - 01-06-2018, 06:17 PM
RE: converting a Kalamazoo 1SM - by Rupert Lucius - 01-10-2018, 08:25 PM
RE: converting a Kalamazoo 1SM - by Mark Reich - 01-07-2018, 09:58 AM
RE: converting a Kalamazoo 1SM - by grepper - 01-07-2018, 12:43 PM
RE: converting a Kalamazoo 1SM - by Ken S - 01-09-2018, 08:40 PM
RE: converting a Kalamazoo 1SM - by Ken S - 01-10-2018, 08:53 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)