11-18-2017, 04:01 PM
(This post was last modified: 11-18-2017, 04:01 PM by Rupert Lucius.)
Edge On Up
Will be doing a production run of Viel/Penn motor combo plates - as soon as Ken receives his prototype plate and gives EdgeOnUp the to go or not to go signal.
If your are interested contact EOU -
EOU will produce ONLY one production run - ONLY ONE RUN.
Ken, or someone will publish a template (no charge) that can be down loaded from this Forum you can create your own plate.
Sharpening Made Easy would be a source??? for plates????
Who knows???
Go ahead an contact EOU if you are interested. EOU is only doing one run, only one run.
Rupert
Will be doing a production run of Viel/Penn motor combo plates - as soon as Ken receives his prototype plate and gives EdgeOnUp the to go or not to go signal.
If your are interested contact EOU -
EOU will produce ONLY one production run - ONLY ONE RUN.
Ken, or someone will publish a template (no charge) that can be down loaded from this Forum you can create your own plate.
Sharpening Made Easy would be a source??? for plates????
Who knows???
Go ahead an contact EOU if you are interested. EOU is only doing one run, only one run.
Rupert