The Toothy Truthy (one version) ;D

[Mark Reich]

 I'll hang out with a normal guy rather than an important one most of the time.  

Thanks Ken, I read that when you posted it and thought, "That's good information!". I'm getting old and stubborn though. Actually I'm forgetful, but I'm old enough to get away with calling it stubbornness. 

Back to this serious business of mega-tooth. 

So far I've done little but reaffirm that anything coarser than about 120-150 grit is beyond toothy, in a few ways. 

Of greatest concern to me by far- It eats up too much steel! You can measure how much steel it takes to touch up, even as gently as possible. If you're sharpening at 1800 SFPM, that's a whole other ballgame. That's how you get burr you can't just feel, you can measure it with a yardstick.     Yeah, it sucks to remove. Especially with an 1800 SFPM machine. You Need Stones!! 

So who uses stones or diamond plates to gain... Teeth of Justice