Kalamazoo 1SMP - Printable Version +- The BESS Exchange is sponsored by Edge On Up (http://bessex.com/forum) +-- Forum: BESS Forums (http://bessex.com/forum/forumdisplay.php?fid=1) +--- Forum: Relevant General Discussion (http://bessex.com/forum/forumdisplay.php?fid=19) +--- Thread: Kalamazoo 1SMP (/showthread.php?tid=559) |
Kalamazoo 1SMP - SHARPCO - 10-18-2020 New Kally. https://www.kalamazooind.com/product/1smp-1-x-42-inch-industrial-multi-position-belt-sander/ RE: Kalamazoo 1SMP - vstrom - 10-19-2020 I saw that yesterday. Seems odd that Kalamazoo would promote something that is not in stock. RE: Kalamazoo 1SMP - blgentry - 10-24-2020 When I was shopping for a sander, I wanted one that I could lay horizontally if I wanted to. This seems to be that sander. I'm not a huge fan of having to use an open end wrench on two different bolts to do it, but I might get used to that. I would really want an angle guide with it that could be used edge trailing though, which means my current KallyRest wouldn't work. So this would be a whole other project. I'm not even sure if I would like horizontal sharpening better than vertical. Seems like a good idea, but you never know until you try. Like the previous poster said, I can't seem to find one for sale anywhere, so I'm not sure what these cost either. So overall, I guess I'm just sticking with what I have for now. Brian. RE: Kalamazoo 1SMP - CasePeanut - 12-06-2020 Two bolts seems annoying if you wanted to flip often. The knife kits.com table seems like a better option to retrofit a standard model. RE: Kalamazoo 1SMP - MaxtheKnife - 12-20-2020 (10-18-2020, 06:36 AM)SHARPCO Wrote: New Kally. i want one bad hope they release it soon |